Page 1 of 1

Downloading the powertap CPU & intervals

Posted: Fri May 01, 2009 5:03 pm
by Virgile
Hi!
The new releases of the hardware firmware (7.53 & now 7.60) are no longer supported by ismarttrain. In addition, intervals/split times are not displayed on ismarttrain.

I tried a beta version (3.0.6 beta 1). OK for downloading 7.6 PT firmware, however total time is wrong (approx 10% more than actual).

In addition, a zoom tool allowing for averaging data between 2 points may be interesting for precise evaluation and analysis of any workout.

Third, what about calculating TRIMPS on power output data when present?

Thanks a lot for this great software. Helps a lot for training management.

Best regards, keep on training
Virgile